AEOTEC Z-Wave Heavy Duty Switch
AEOTEC Z-Wave Heavy Duty Switch can switch powered electrical devices and appliances that draw up to 40 amps or 9600 Watts of power.
Includes built-in Z-Wave signal repeater and extended Z-Wave wireless range (up to 150m outdoors).
Rated IP44 for both outdoor and indoor use.
Electronics that use up to 40 amps of power.
They’re the big electronics and appliances in your home. Big fridges and pool pumps. Hot water systems and electric car chargers.
If it’s big, if it uses a lot of power, Heavy Duty Smart Switch was made for it.
Requires professional installation.
The AEOTEC Z-Wave Heavy Duty Switch must be installed by a licensed electrician.
Important safety information.
Warning: Be careful of electric shock. Only installation and maintenance personnel should operate this button.
Please read this and other device guides carefully.
Failure to follow the recommendations set forth by Aeotec Limited may be dangerous or cause a violation of the law.
The manufacturer, importer, distributor, and / or reseller will not be held responsible for any loss or damage resulting from not following any instructions in this guide or in other materials.
A licensed electrician with knowledge and understanding of electrical systems and safety should complete the installation.
Keep product away from open flames and extreme heat. Avoid direct sun light or heat exposure.
Heavy Duty Smart Switch Gen5 current can not exceed 40 amps.
Contains small parts; keep away from children.
Z‐Wave Plus (500 series chip)
921.42Mhz ‐ AU/NZ approved RF for Z‐wave
Z‐Wave device type
Up to 40m without obstacles
Indoor/Outdoor use, IP44
0 ~ 50 °C
‐10 ~ 60 °C
4.8 x 2.8 x 1.3 inches
Z-Wave Plus certified